Action Commands - Campbell CELL200 Series Product Manual

set power duration ###
set power repeat ###
set power start ###
set ppp pass ###
set ppp user ###
set roaming ###
set sdc ###
set trusted 1 ###
set trusted 2 ###
set trusted 3 ###
set trusted 4 ###
set ping ###
D.4 Action commands
Action commands are used to perform actions on the modem such as entering low power mode,
rebooting, checking for updates, clearing usage, and more.
Sets the on duration, in minutes. ### is a number. Accepted values
are: 5, 10, 15, 20, 25, 30, 35, 40, 45, 50, 60, 120, 180, 240, 300, 360,
420, 480, 540, 600, 660, 720, 780, 840, 900, 960, 1020, 1080, 1140,
1200, 1260, 1320, 1380, and 1439.
Sets the modem repeat cycle. ### is a number. Accepted values
are: 1441, 15, 20, 30, 40, 50, 60, 120, 180, 240, 300, 360, 420, 480,
540, 600, 660, and 720. A value of 1441 or greater will disable the
repeat cycle.
Sets the modem Start (power-on) Time, in minutes. ### is a
number. Only 15 min increments are accepted (0, 15, 30 to 1440). A
value of 1440 will set the modem to "Always On".
Sets the PPP protocol password. ### is a string.
Sets the PPP protocol username. ### is a string.
Sets the roaming capabilities of the cellular modem. ### is a string.
Accepted values are Auto and Disabled .
Sets the modem SDC address for the CS I/O port. ### is a number.
Accepted values are 7 , 8 , 10 , and 11 .
Sets the address or DNS Names in the 1st Trusted IP Host field. ###
is a string.
Sets the address or DNS Names in the 2nd Trusted IP Host field.
### is a string.
Sets the address or DNS Names in the 3rd Trusted IP Host field.
### is a string.
Sets the address or DNS Names in the 4th Trusted IP Host field.
### is a string.
Enables or disables ping in the modem. ### is a string. Disabled
and Enabled are the only two values that are accepted.
CELL200-Series 4G LTE Cellular Module 78