Cell200 Series And Data Logger Configuration; Integrated Mode Option; Non-Integrated Mode Option - Campbell CELL200 Series Product Manual

regulations of the Federal Communications Commission (FCC), Industry Canada, ACMA in
Australia, or your country's regulatory body.
8.4 CELL200 series and data logger
configuration
NOTE:
Instructions in this section assume that the steps in Pre-installation (p. 2) have been
completed. Cellular service must be setup before web access using
available.
Select the installation option that best suits your application. The Overview (p. 8) section
describes the differences.

8.4.1 Integrated mode option

8.4.2 Non-integrated mode option

8.4.3 Serial server mode option
8.4.4 Serial client mode option
8.4.5 Serial server/client mode option

8.4.1 Integrated mode option

QuickStart (integrated
with its default settings.
If the module is not in its default settings, the settings in the CELL200 series must match those in
the data logger for integrated mode to work. This includes the SDC Address for CS I/O
communications or the RS-232 Baud Rate for RS 232 communications. Once these settings
match, all other configuration changes can be done in the data logger as described in
(integrated mode) (p. 10).
See Non-integrated mode
CELL200 series and data logger.

8.4.2 Non-integrated mode option

In non-integrated mode, the module mimics the behaviour of our older cellular modems. This
mode should be used when doing a direct replacement of a Raven or an RV50 modem.
mode) (p. 10) describes setting up the CELL200 series in integrated mode
option (p. 35) for information on changing these settings in the
cell.linktodevice.com
CELL200-Series 4G LTE Cellular
is
35
35
41
47
53
QuickStart
Module 35