Set Up Hardware; Set Up Loggernet - Campbell CELL200 Series Product Manual

4g lte cellular module

Hide thumbs Also See for CELL200 Series:

Table of Contents

After LoggerNet receives the variable "Callback" it will begin collecting data from the data logger

and store it to a file based on the data collection settings in the Setup window. See the CRBasic

help for more information.

8.4.4.3 Set up hardware

1. Connect the cellular antenna, if it is not already connected. When using a MIMO antenna

with multiple cellular connections, connect the primary cable to Cellular and the secondary

to Diversity. If the cables are not marked in this way, they can be connected to either

antennna port.

2. Connect your data logger RS-232 or CS I/O port to the CELL200-series module RS-232 or

CS I/O port. Ensure the same port is used for each device, for example RS-232 to RS-232.

See

Wiring and

3. If not connecting through CS I/O, provide power to the CELL200 series. The data logger

provides power through the CS I/O port. USB power is not sufficient to power the CELL200

series; 12 V is required.

The LoggerNet Network Map is configured from the LoggerNet Setup screen.

NOTE:

Setup has two options, EZ (simplified) and Standard. Click on the View menu at the top of the

Setup screen, and select Standard view.

From the LoggerNet toolbar, click Main > Setup and configure the Network Map as described in

the following steps:

1. Select Add Root > PakBusTcpServer.

2. Add a data logger to the PakBusTcpServer.

connections (p. 29).

CELL200-Series 4G LTE Cellular

Module 51

Table of Contents