Wiring And Connections; Module Communications Connections - Campbell CELL200 Series Product Manual

4G/3G Cellular Whip Antenna with SMA Connector: A wideband termination antenna
o
with SMA connector and articulating base. This antenna is intended for short-term
testing use only. It is not intended for long-term use. Campbell Scientific
recommends that customers use external antennas for the best reception and
transmission of cellular signals.
NOTE:
When antennas are located away from the CELL200 series, keep the cables as short as
possible to prevent the loss of antenna gain. Route the cables to protect them from damage
and so they will not be snagged or pulled on. Avoid binding or sharp corners in the cable
routing. Bundle and tie off excess cable. Make sure the cables are secured so their weight will
not loosen the connector from the CELL200 series over time.
TIP:
Cellular phone apps, such as OpenSignal
point an antenna to get the best signal strength.

8.3 Wiring and connections

This section explains how to connect the module for different communications methods. It also
describes how to power the module and connect an antenna.

8.3.1 Module communications connections

The following table shows communications options for each Campbell Scientific data logger
model.
(https://opensignal.com/
CELL200-Series 4G LTE Cellular
), show the direction to
Module 29