Modules Using Konect Pakbus Router (Private Dynamic Ip); Set Up Hardware - Campbell CELL200 Series Product Manual

4g lte cellular module

Hide thumbs Also See for CELL200 Series:

Table of Contents

6.1 Modules using Konect PakBus Router

(private dynamic IP)

1. Connect the cellular antenna, if it is not already connected. When using a MIMO antenna

with multiple cellular connections, connect the primary cable to Cellular and the secondary

to Diversity. If the cables are not marked in this way, they can be connected to either

antennna port.

2. Connect your data logger RS-232 or CS I/O port to the CELL200-series module RS-232 or

CS I/O port. Ensure the same port is used for each device, for example RS-232 to RS-232.

See

Wiring and

3. If not connecting through CS I/O, provide power to the CELL200 series. The data logger

provides power through the CS I/O port. USB power is not sufficient to power the CELL200

series; 12 V is required.

Figure 6-2. Module with public static IP address

connections (p. 29).

CELL200-Series 4G LTE Cellular

Module 11

Table of Contents