Test The Connection - Campbell CELL200 Series Product Manual

7. Select the data logger in the Network Map and set the PakBus Address to match that of the
data logger (default address in the data logger is 1). If a PakBus Encryption Key was entered
during data logger setup, also enter it here. Click Apply to save the changes.

8.4.2.5 Test the connection

After the Network Map has been configured, test the cellular connection by using the Connect
screen as shown in the following image. Click on the appropriate station and click Connect to
initiate a call to the data logger.
TIP:
The connection time is subject to many external factors. It is often less than 30 seconds but
could be up to 15 minutes. Be patient.
CELL200-Series 4G LTE Cellular Module 40