Configure Cell200 Series - Campbell CELL200 Series Product Manual

"serial client" mode and all data on the active port will be sent and received through the initiated
TCP client socket connection.
The incoming connection, or serial server mode, takes precedence. An outbound, or client,
connection will be interrupted if a connection is made on the incoming, or server, listening port.
NOTE:
Instructions in this section assume that you have established cellular service and the SIM card
has been installed as described in

8.4.5.1 Configure CELL200 series

To set up the CELL200 series in serial server/client mode:
1. Connect a USB cable between your module and computer.
2. Connect the cellular antenna, if it is not already connected. When using a MIMO antenna
with multiple cellular connections, connect the primary cable to Cellular and the secondary
to Diversity. If the cables are not marked in this way, they can be connected to either
antennna port. See
3. Open a web browser and go to:
TIP:
If this doesn't work browse to 192.168.86.1.
4. On the Settings tab, enter the APN provided by your cellular provider.
5. On the General tab, set Mode to Serial Server/Client.
QuickStart (integrated
Antenna connections (p. 33).
cell.linktodevice.com
mode) (p. 10).
.
CELL200-Series 4G LTE Cellular Module 54