Set Commands - Campbell CELL200 Series Product Manual

show state
show state num
show time
show trusted 1
show trusted 2
show trusted 3
show trusted 4
show update check
show update results
show usage lastmonth
show usage month
show usage today
show usage yesterday
D.3 Set commands
Set commands are used to set specific settings in the device. Most settings will not take effect
until the module is rebooted.
Returns the modem state in English. Values returned could include
(but not limited to) "Power off.", "Powering up.", "Powered up.",
"SIM authorized.", "Setting baud rate.", "Waiting for baud rate.",
"Baud rate set.", "Baud rate failure.", "Power off. Waiting for retry.",
"Powered up. SIM auth failure.", "Querying modem.", "Waiting for
network registration.", "Configuring modem.", "Dialing.", "Dialing
(retry).", "Dialed.", "PPP negotiation.", "Network ready.", "PPP
closing.", "PPP paused.", "PPP dropped.", "Terminal AT command
mode.", "Firmware update mode.", "Shutting down."
Returns the state number associated with show state values.
Returns the modem current time. Time returned by the modem is
set by the cellular network.
Returns the address or DNS Name in the 1st field of the cellular
module Trusted IP Host setting.
Returns the address or DNS Name in the 2nd field of the cellular
module Trusted IP Host setting.
Returns the address or DNS Name in the 3rd field of the cellular
module Trusted IP Host setting.
Returns the address or DNS Name in the 4th field of the cellular
module Trusted IP Host setting.
Returns information concerning the last update check.
Returns the results of a modem operating system update.
Returns the number of bytes used across the cellular network in the
previous month.
Returns the number of bytes used across the cellular network in the
current month.
Returns the number of bytes used across the cellular network since
midnight.
Returns the number of bytes used across the cellular network
during the previous day.
CELL200-Series 4G LTE Cellular Module 76