Install The Sim Card - Campbell CELL200 Series Product Manual

4.2 Install the SIM card

NOTE:
If you purchased cellular service from Campbell Scientific with the module, it will come with
the SIM (Subscriber Identity Module) card already installed. Proceed to
setup (p. 5).
NOTE:
Some SIM cards, particularly those purchased in Germany, come with an active personal
identification number (PIN). The PIN must be deactivated before proceeding. Often, an easy
way to deactivate the PIN is to install the SIM card in a mobile phone and use the device
settings.
The CELL200 series requires a Micro-SIM (3FF) (6 position / contacts); a smartcard that securely
stores the key identifying a mobile subscriber. You should only need to install the SIM card once
in the life of the module.
To install the SIM card:
1. Remove the SIM card cover.
2. Note the location of the notched corner for correct alignment. The gold contact points of
the SIM face down when inserting the SIM card as shown in the following figure. Gently
slide the card into the slot until it stops and locks into place. To eject the SIM card, press it
in slightly and release.
3. Replace the SIM card cover.
Figure 4-1. SIM card installation
Konect PakBus Router
CELL200-Series 4G LTE Cellular Module 4