Ii-4-4 Basic Configuration Sync - Draytek VigorAP 906 User Manual

II-4-4 Basic Configuration Sync

If you add one Mesh Node in a mesh group, the Mesh Root will send the basic configuration to the
device. This page could help you to change the Mesh Root settings and deliver the new
configuration of the Mesh Root to all "connected" Mesh Nodes.
Available settings are explained as follows:
Item
System Maintenance /
Wireless LAN (2.4Hz) /
Wireless LAN (5GHz)
Tips for Mesh Network Setup
Set up TWO mesh devices with uplink RSSI larger than -65dBm.

Upgrade the firmware version of Mesh devices through the Mesh link, starting from the mesh

device with less hop number. For example, upgrade the firmware from the root, hop1 Mesh
Node then hop2 Mesh Node, and so on.
VigorMesh network supports up to 3 hops of mesh devices. However, it is suggested to connect

the mesh group with less than or equals to 2 hops.
For your reference, we make a real mesh environment test and get the following record. (Use
VigorAP APP to do an internet speed test with different hop mesh nodes.)
Internet Download Speed (for root and hop1 ~ hop3):
iPad connects to Root
iPad connects to hop1 Node : 49Mbps (Uplink RSSI : -55dBm)
iPad connects to hop2 Node : 41Mbps (Uplink RSSI : hop2 -64dBm / hop1 -55dBm)
Description
Check the item(s) you want to make configuration sync.
Apply – Click it to apply the settings configured by such AP to all
connected mesh nodes. Note that this button is available only
when such AP is in mesh root mode.
: 80Mbps
72