Table of Contents
Advertisement
WPS SSID
WPS Auth Mode
WPS Encrypt Type
Configure via Push
Button
Configure via Client
PinCode
II-3-5 Advanced Setting
This page is to determine which algorithm will be selected for wireless transmission rate.
Available settings are explained as follows:
(encryption) function of VigorAP 906 is properly configured, you can
see the 'Yes' message here.
Display current selected SSID.
Display current authentication mode of the VigorAP 906. Only WPA2
Personal and WPA Personal support WPS.
Display encryption mode (None, WEP, TKIP, AES, etc.) of VigorAP 906.
Click
Start PBC
to invoke the Push-Button style WPS setup procedure.
VigorAP 906 will wait for WPS requests from wireless clients for about
two minutes. Both ACT and 2.4G WLAN LEDs on VigorAP 906 will blink
quickly when WPS is in progress. It will return to normal condition
after two minutes. (You need to set up WPS within two minutes)
Enter the PIN code specified in the wireless client you wish to connect
with and click
the Start PIN
on VigorAP 906 will blink quickly when WPS is in progress. It will return
to normal condition after two minutes. (You need to set up WPS
within two minutes).
41
button. Both ACT and 2.4G WLAN LEDs
Advertisement
Table of Contents
