Table of Contents
Advertisement
SSID
Subnet
Isolate LAN
Isolate Member
VLAN ID
PHY Mode
Peer MAC Address
After finishing this web page configuration, please click OK to save the settings.
SSID or just cannot see anything about VigorAP 906 while site
surveying. The system allows you to set four sets of SSID for different
usage.
Set a name for VigorAP 906 to be identified. Default settings are
DrayTek-LAN-A and DrayTek-LAN-B. When
enabled, you can specify the subnet interface (LAN-A or LAN-B) for
each SSID by using the drop-down menu.
Choose LAN-A or LAN-B for each SSID. If you choose LAN-A, the
wireless clients connecting to this SSID could only communicate with
LAN-A.
Check this box to make the LAN clients not access each other.
Check this box to make the wireless clients (stations) with the same
SSID not access each other.
Enter the value for such SSID. Packets transferred from such SSID to
LAN will be tagged with the number.
If your network uses VLANs, you can assign the SSID to a VLAN on
your network. Client devices that associate using the SSID are grouped
into this VLAN. The VLAN ID range is from 3 to 4095. The VLAN ID is 0
by default, it means disabling the VLAN function for the SSID.
Data will be transmitted via HTMIX mode.
Each access point should be set up to the same Phy Mode for
connecting with each other.
Enter the peer MAC address for the access point that VigorAP 906
connects to.
35
Enable 2 Subnet
is
Advertisement
Table of Contents
