Table of Contents
Advertisement
When Mesh Root is
selected
When Mesh Node is
selected
Mesh Group
Add Mesh Node
Backup Mesh Config
Wireless Downlink Band – Choose a wireless band for connecting
with a downlink mesh root or a downlink mesh node.
Group Name - Display the name of the current mesh group.
Auto Reselect - It is selected in default. To perform the auto reselect,
make sure the process for CFG Sync and CFG Check for mesh nodes
are successful. If enabled, after changing the environment of the
mesh network (e.g., offline, disconnection), the root device will
perform auto reselect to reconstruct the mesh network.
Wired Uplink – Check the box if such VigorAP connects to an uplink
mesh root or an uplink mesh node with an Ethernet cable.
Wireless Uplink/Downlink Band – Choose a wireless band for
connecting with an uplink/downlink mesh root or an uplink/downlink
mesh node.
When the VigorAP is set as mesh root or is added to a mesh group,
the basic information including role, MAC address, and model name
of the AP will be shown in this area.
Up to 8 entries (one mesh root and seven mesh nodes) will be shown
on this field.
Reset - Click it to clear the Mesh Group information.
Delete - Click it to remove the selected entry.
Click
Search
to find out the available mesh node on the network.
Check the one you want and click Apply. The selected AP will be
added to the current mesh root.
Backup – Click the button to save the configuration as a file.
Upload/Restore – Click the Upload button to specify a configuration
file. Then click Restore to apply the configuration.
When the MAC address of such VigorAP does not appear under the
mesh group, the restore operation will not succeed and the error
message, "Device MAC is not in mesh group list", will be shown
instead.
66
Advertisement
Table of Contents
