Table of Contents
Advertisement
III-1-9 Management
This page allows you to specify the port number for HTTP and HTTPS servers.
Available parameters are explained as follows:
Item
Device Name
Access Control
Port Setup
TLS Encryption Setup
Panel Control
Description
The default setting is VigorAP 906. Change the name if required.
Check the box(es) listed in this area to enable the various servers.
HTTP port/HTTPS port -Specify user-defined port numbers for the
HTTP and HTTPS servers.
TLSv1.2/ TLSv1.1 or above/TLSv1.0 or above – Check the box to
enable TLS encryption protocols.
For improved security, the HTTPS servers that are built into the router
have been upgraded to TLS 1.x protocol.
Disable LED - The LEDs blink always since VigorAP is powered on.
Some people might not like that. Therefore the function of LED is
allowed to be disabled to make people feeling comfortable and
undisturbed. After checking it, all the LEDs on VigorAP will light off
immediately after clicking OK
Enable Default Configuration Wizard – The default setting is
enabled. When it is enabled, you will be guided into Quick Start
Wizard whenever clicking the DrayTek logo on the top of the web
user interface.
Such function will be disabled if you have configured Operation Mode,
100
.
Advertisement
Table of Contents
