Hardware Installation; I-2-1 Wired Connection For Pc In Lan - Draytek VigorAP 906 User Manual

I-2 Hardware Installation
This section will guide you to install the VigorAP 906 through a hardware connection and configure
the device's settings through the web browser.
Before starting to configure VigorAP 906, you have to connect your devices correctly.

I-2-1 Wired Connection for PC in LAN

1. Connect VigorAP 906 to xDSL modem, router, or switch/hub in your network through the LAN
B port of the access point by Ethernet cable.
You can also connect VigorAP 906 to a Vigor router via wireless connection. For detailed
information, refer to VigorAP 906 User's Guide.
2. Connect a computer to other available LAN A port. Make sure the subnet IP address of the PC
is the same as VigorAP 906 management IP, e.g., 192.168.1.X.
3. Connect the A/C power adapter to the wall socket, and then connect it to the PWR connector
of the access point.
4. Power on VigorAP 906.
5. Check all LEDs on the front and back panel. The ACT LED on the front panel should blink;
WAN/LAN LED on the back panel should be on if the access point is correctly connected to the
xDSL modem, router or switch/hub.
(For detailed information on LED status, please refer to section I-1-1.)
4