Ii-3-5 Advanced Setting - Draytek VigorAP 802 User Manual

WPS SSID
WPS Auth Mode
WPS Encrypt Type
Configure via Push
Button
Configure via Client
PinCode

II-3-5 Advanced Setting

This page is to determine which algorithm will be selected for wireless transmission rate.
Available settings are explained as follows:
(encryption) function of VigorAP 802 is properly configured, you can
see 'Yes' message here.
Display current SSID.
Display current authentication mode of the VigorAP 802. Only
WPA2/PSK and WPA/PSK support WPS.
Display encryption mode (None, WEP, TKIP, AES, etc.) of VigorAP 802.
Click Start PBC to invoke Push-Button style WPS setup procedure.
VigorAP 802 will wait for WPS requests from wireless clients about two
minutes. Both ACT and 2.4G WLAN LEDs on VigorAP 802 will blink
quickly when WPS is in progress. It will return to normal condition
after two minutes. (You need to setup WPS within two minutes)
Type the PIN code specified in wireless client you wish to connect, and
click Start PIN button. Both ACT and 2.4G WLAN LEDs on VigorAP 802
will blink quickly when WPS is in progress. It will return to normal
condition after two minutes. (You need to setup WPS within two
minutes).
38