Setup Menu - Lexmark Optra Optra T Administrator's Manual

Attendance message Meaning and required action
35 Res Save Off The printer lacks the memory needed to enable
Deficient Memory memory is allocated for one or more of the printer link buffers.
To enable
• Install additional memory, or
• Set the link buffer to Auto, and exit the menus to activate the link buffer changes. When
Press
37 Insufficient The printer memory used to store pages of data is too full to collate the rest of the print job.
Collation Area
• Press
• Cancel the current job. Press
• Reset the printer. Press
Note: Resetting the printer deletes all current data from the print buffer, including all Print and Hold jobs. See
Printer" on page
37 Insufficient The printer memory used to store undeleted flash resources is too full to perform the flash memory defragment
Defrag Memory operation.
• Press
To perform the defragment operation, you can:
• Delete fonts, macros, and other data in printer RAM.
• Install additional printer memory.
Understanding Printer Messages
Resource Save after this message displays:
Resource Save from the

SETUP MENU

Go to disable Resource Save
Go to clear the message, print the portion of the job already in memory, and collate the rest of the job.
displays. Press Select.
Menu>
displays. Press Select.
43.
Go to clear the message.
Resource Save. This message usually indicates that too much
and modify the link buffer again.
and continue printing.
Menu> or <Menu to enter the
or <Menu to enter the JOB
105
Ready
JOB MENU. Press Menu> or
MENU. Press Menu> or <Menu
displays, enable
<Menu until Cancel Job
until Reset Printer
"Reset