Lexmark Optra Optra T Administrator's Manual page 100

Status message Meaning and allowed action
Ready Hex The printer is ready and
Trace
do not execute.
• Turn the printer off to exit
• Press
• Reset the printer. Press
displays. Press Select.
Note: Resetting the printer deletes all current data from the print buffer, including all Print and Hold jobs. See
Printer" on page
Res Reduced The resolution of the page is reduced from 600 dots per inch (dpi) to 300 dpi to prevent a
1200 dpi pages do not undergo resolution reduction. If a 1200 dpi print job runs out of memory, a
occurs.
Resetting The printer is setting the active bin back to the first bin of a set of linked bins.
Active Bin
No button actions are possible while this message displays.
Resetting the The printer is deleting any print jobs in process and restoring all printer settings to user defaults.
Printer
No button actions are possible while this message displays.
Restoring Factory The printer is restoring factory defaults. See
Defaults
No button actions are possible while this message displays.
Unlocking Menus If the operator panel menus are disabled, this message briefly displays after they are enabled. See
panel menus" on page
No button actions are possible while this message displays.
Understanding Printer Messages
Hex Trace
is selected, all data sent to the printer prints in hexadecimal and character representation. Control codes print, but
Hex Trace.
Stop to take the printer offline.
Menu> or
43.
Res Reduced displays for the duration of the current job.
12.
mode is active. Hex Trace isolates the source of a print job problem. When
Not Ready displays and no data is processed. Press
<Menu to enter the JOB MENU. Press
page 92 for details about which printer settings are affected.
100
Go to return to Ready.
Menu> or <Menu until Reset Printer
38 Memory Full
38 Memory Full
"Disabling operator
Hex
"Reset
error.
error