Reports Menu; Universal Setup Menu - Lexmark M3150dn User Manual

Understanding the printer menus

Universal Setup menu

Use
Units of Measure
Inches
Millimeters
Portrait Width
3–8.5 inches
76–216 mm
Portrait Height
3–14.17 inches
76–360 mm
Feed Direction
Short Edge
Long Edge

Reports menu

Reports menu
Use
Menu Settings Page
Device Statistics
To
Identify the units of measure.
Notes:
•
Inches is the US factory default setting.
•
Millimeters is the international factory default setting.
Set the portrait width.
Notes:
•
If the width exceeds the maximum, then the printer uses the
maximum width allowed.
•
8.5 inches is the US factory default setting. You can increase
the width in 0.01‑inch increments.
•
216 mm is the international factory default setting. You can
increase the width in 1‑mm increments.
Set the portrait height.
Notes:
•
If the height exceeds the maximum, then the printer uses the
maximum height allowed.
•
14 inches is the US factory default setting. You can increase the
height in 0.01‑inch increments.
•
356 mm is the international factory default setting. You can
increase the height in 1‑mm increments.
Specify the feed direction if the paper can be loaded in either
direction.
Notes:
•
Short Edge is the factory default setting.
•
Long Edge appears only when the longest edge is shorter than
the maximum width supported in the tray.
To
Print a report containing information about the paper loaded in trays,
installed memory, total page count, alarms, timeouts, printer control panel
language, TCP/IP address, status of supplies, status of the network
connection, and other information.
Print a report containing printer statistics such as supply information and
details about printed pages.
60