Lexmark Optra Optra T Administrator's Manual page 110

Attendance message Meaning and required action
55 Insufficient The printer link buffer used to process data is too full to receive an incoming fax.
Fax Buffer
This message usually displays when the printer is busy receiving, processing, or printing data from a host interface
connection while fax data is being received through a serial interface port configured for fax processing.
• Press
• Reset the printer. Press
Note: Resetting the printer deletes all current data from the print buffer, including all Print and Hold jobs. See
Printer" on page
After this message displays, the connection between the printer and the sending fax machine is broken. The printer
will not accept additional fax data until sufficient fax buffer space is made available. However, any fax data stored in
the fax buffer is printed. See
56 Standard Data is sent to the printer across the serial port, but the serial port is disabled. When the serial error displays, the
Serial Disabled reporting of other serial errors is suppressed until the menus are entered or the printer is reset.
56 Serial Note: This error is not detected for optional serial ports on an Tri-Port interface card.
Port x Disabled
If this message displays:
• Make sure
• Press
• Reset the printer. Press
Note: Resetting the printer deletes all current data from the print buffer, including all Print and Hold jobs. See
Printer" on page
Understanding Printer Messages
Go to clear the message and continue printing. However, some data may not print or may not print correctly.
Menu>
displays. Press Select.
43.
"Fax Menu" on page
Serial Buffer in the
Go to clear the message. The printer discards any data received on the serial port.
Menu>
displays. Press Select.
43.
or <Menu to enter the JOB MENU. Press
84.
SERIAL MENU is not set to Disabled.
or <Menu to enter the JOB MENU. Press
110
Menu> or <Menu until Reset Printer
Menu> or <Menu until Reset Printer
"Reset
"Reset