Table of Contents
Advertisement
2 S a f e t y a n d C a r e
Installing a Battery Pack
Caution: There is only one correct orientation for attaching the battery
connector. Do not force or twist the connector because doing so can damage
the battery pack and the ultrasound system.
To install a battery pack:
1. Orient the battery pack connector at the end of the battery cable with
the receptacle on the ultrasound system, located within the battery
recess. Firmly push them together.
2. Turn the battery pack so that the hook and loop fastener on the battery
pack is toward the battery recess in the right rear panel, and press the
battery pack into the recess, connecting the hook and loop fastener on
the battery pack with the hook and loop fastener in the recess.
3. Position the battery wires so they are neatly stored within the battery
recess.
To replace the storage bin cover:
1. Locate the support plate on the inside of the lower left (from outside)
corner of the storage bin cover.
2. Hook the lower edge of the support plate over the attachment plate on
the right rear panel.
3. Slide the storage bin cover downward onto the attachment plate and
rotate the right side of the storage bin cover toward the ultrasound
system.
Ensure the panels are connected by gently pulling on the left side of the
storage bin cover.
Aligning the support plate over the attachment plate.
4. Once the plates are connected, align and connect the fastener pins.
Working from the lower left toward the upper right of the storage bin
cover, align the fastener pins with the pin receptacles and press to snap
the storage bin cover into place on the right rear panel.
2 - 2 8
1 Attachment plate
2 Right rear panel
3 Support plate
4 Storage bin cover
[ 1 ]
I N S T R U C T I O N S
F O R
U S E
Advertisement
Chapters
Table of Contents
