Storing Clips - Siemens ACUSON Antares Instructions For Use Manual

5 B e g i n n i n g a n E x a m i n a t i o n

Storing Clips

Note: Clips cannot be stored from the Review task card. Clips cannot be stored from
the Compose task card during 3-Scape Imaging, unless the volume is being
automatically rotated. Clips are not compatible with SieScape.
You can acquire and store clips to the system's hard disk during a patient
examination.
Use the system presets to configure clip protocols that determine the data
captured for clips. You can store clips from the Review task card.
Use the system presets to choose the required output format for stored
images and clips.
During acquisition of the clip, the system displays a counter representing the
VOL/CLIP SAVE key on the lower right of the screen. The counter indicates
the number of times clips were stored during the current study. The system
removes the counter from the screen when clip acquisition and storage is
complete.
Specify the length for stored clips by selecting a capture definition from the
Protocol group box.
To acquire and store a
clip of this length:
Specified length (selected
capture definition)
Truncated length
Greater than specified
length
5 - 1 4
Do this...
Press the VOL/CLIP SAVE key on the control panel.
Press the VOL/CLIP SAVE key on the control panel,
then press the key again to stop acquisition.
Press and hold the VOL/CLIP SAVE key on the
control panel, then release the key to stop acquisition.
DIMAQ Protocols
Print/Store
[1] Instructions for Use
Choosing the
Output Format
for Images
[ 1 ] I N S T R U C T I O N S F O R
Ch 4
U S E