System Startup; Ac Tray Panel; Plugging In The System - Siemens ACUSON Antares Instructions For Use Manual

System Startup

The first step to operating the ultrasound system is to connect the system
to a power source.

AC Tray Panel

Identify the version of the AC tray panel on your system using the
illustrations. The AC tray panel on your system may have a connector cover
for protection of the power cord.
xxxV~
xx/xxHz
xA
Example of AC Tray panel with a connector cover.

Plugging in the System

The ultrasound system has a non-detachable power cord.
WARNING: For 115V units only: To ensure grounding reliability, connect the
system only to a hospital-grade power receptacle.
To plug in the system:
Connect the power cord plug to the MAINS supply in the following
manner:
230V systems
to a 230V standard MAINS, i.e., "Schuko" receptacle
–
(CEE 7-7 standard).
115V systems
to a hospital-grade MAINS receptacle.
–
100V systems
– to a standard 100V MAINS receptacle.
[ 1 ] I N S T R U C T I O N S F O R
Example of AC Tray panel without connector cover.
U S E
4 S y s t e m S e t u p
1 Power cord
connector
2 Equipotential
connector
3 Service
diagnostic lights
4 MAINS circuit
breaker
1 2 3
I = ON
4 6
5
= OFF
4 - 1 1