Mobile Quikstart For Portable Studies (Standby) - Siemens ACUSON Antares Instructions For Use Manual

Ultrasound imaging system
Table of Contents

Advertisement

To power off the system:
1. Briefly press and then release the power on/off switch ( ) to power
off the ultrasound system.
2. Select the Shut Down button on the displayed System Shut Down
dialog box.
If the system is transferring images, then it will wait until the transfer is
complete to power off.
Wait approximately 20 seconds after the system powers off before
powering on ( ) the ultrasound system.

Mobile QuikStart for Portable Studies (Standby)

The Mobile QuikStart optional feature for portable studies decreases the
time required to power the system on or off by using the installed battery to
place the ultrasound system in a standby status.
The system can maintain the standby status for approximately four hours
when the system's power cord is not plugged into the power supply.
To place the system in a standby status:
1. Briefly press and then release the power on/off switch ( ) to power off
the ultrasound system.
2. Select the Standby button on the displayed System Shut Down
dialog box.
Note: If the system detects errors that require a system shutdown, then the
Standby button is not available. You can either select Cancel or power off the
system.
If the system is transferring images, then it will wait until the transfer is
complete to power off.
Wait approximately 20 seconds after the system powers off before
powering on ( ) or unplugging the ultrasound system.
[ 1 ]
I N S T R U C T I O N S
F O R
U S E
4 S y s t e m S e t u p
4 - 1 3

Advertisement

Table of Contents
loading

Table of Contents