Aux/Hitch/Pto Fault Code 17 - New Holland T8010 Manual

Hitch Position Command Potentiometer Failure
Cause:
The Data Bus signaled that the hitch position command potentiometer has failed.
The hitch controller received the signal from the armrest controller.
Possible failure modes:
1. The hitch position command potentiometer failed in the armrest controller (in most cases).
2. Software execution error in the armrest controller (small chance).
Solution:
The hitch position command potentiometer is hard wired to the armrest controller. If the hitch position command
potentiometer fails in the armrest controller, the fault code ARM 69 should exist.
1. Check for fault code ARM 69 at the armrest controller. If ARM 69 exists, follow the corresponding corrective
action.
2. Check the function the armrest controller.
NOTE: See schematic section 47 on the schematic poster.
Section 55 - Electrical System, Controller - Chapter 3

AUX/HITCH/PTO FAULT CODE 17

55-3-16