Compressor Installation - New Holland T8010 Manual

Hide thumbs Also See for T8010:

Table of Contents

Compressor Installation

IMPORTANT: If a new compressor is to be installed, its oil level must be adjusted to match the removed

compressor. See Oil Level Check or Adjustment, page 79.

Install the compressor with the three bolts removed

earlier. Torque to 29 ± 4 ft lb (39 ± 4 Nm).

IMPORTANT: Install the ring terminal ground to the

upper front bolt when installing the compressor.

Slowly remove the protective cap, and install the 90°

elbow in the suction port on the compressor.

NOTE: Use caution when removing the caps on a

new compressor; new compressors are pressurized

when shipped.

Install a new O-ring and connect the low pressure

line to the 90° elbow. Suppor t the elbow with a

wrench when connecting the line.

NOTE: Lubricate the O-ring with mineral oil before

installation.

Section 50 - Climate Control - Chapter 2

Table of Contents

T8020 T8030 T8040