Required Tools - New Holland T8010 Manual

3. Rotate the compressor clockwise to check for
binding caused by the presence of particles.
4. Drain or add PAG to return the compressor to
measured dipstick level.
IMPORTANT: Flushing solvent CANNOT be used to
remove compressor contaminants.

Required Tools

The following tools are required when flushing an A/C system or components:
Power Flush 17550
Flush Gun Kit 17585
New Holland A/C Flushing Solvent, one case of
six one gallon containers, BS33801
Dry shop air source, use filter below or equivalent:
Coalescing air filter/dryer (Ingersoll-Rand IR5CHE or
Grainger 4KR65). Desiccant-type air driers should
not be used.
Adapters to connect flush unit to the various A/C
sys tem com ponents. Thes e adapters can be
purchased in kit form or built in the shop.
Clear Plastic Reinforced Hose to connect the tank
to var ious components and small lengths for
bypassing components like the receiver-drier or
thermal expansion valve.
See SPECIAL TOOLS, page 4 in this Section.
Optional tools include:
Pressure regulator to control flow to the flush unit;
regulator must be capable of delivering 45-90 psi
(310-620 kPa) at 4.0 cfm (310 kPa at 0.11 cmm). Do
not exceed 90 psi (620 kPa).
P r e s s u r e i n d i c a t o r g a u g e ( w h i c h m ay b e
integrated into the pressure regulator)
Section 50 - Climate Control - Chapter 2
50-2-35
Additional system flushing is at the discretion of the
service technician who can best judge how far the
contamination has traveled and what components
may have been damaged and require replacement.
Power Flush 17550
Flush Gun Kit 17585
RR00F093
RP00G007