Operating The Power Take Off (Pto) - New Holland LS35-16H Operator's Manual

6. Turn the ignition key and hold it in the start position
(Fig. 5). When the engine starts, release the key.
Important
If the engine does not start after 10 seconds
of continuous cranking, turn the ignition key to off and let
the starter motor cool for 60 seconds; refer to
Troubleshooting, page 34.
7. After the engine starts, move the choke lever to off.
Slowly move the throttle to the desired setting (Fig. 4).
If the engine stalls or hesitates, move the choke lever
back to on for a few seconds. Then move the throttle
lever to desired setting. Repeat this as required.
1
Figure 3
1. PTO—off
2. Choke–on
1
2
Figure 4
1. Fast
2
3
1206
3. Choke–off
1207
2. Slow
14
1
Figure 5
1. Off
2. Lights
Stopping the Engine
1. Push the PTO (power take off) to off (Fig. 3).
2. Move the throttle lever to slow (Fig. 4).
3. Let engine idle for 30–60 seconds.
4. Turn the ignition key to off (Fig. 5).
Operating the
Power Take Off (PTO)
The power take off (PTO) engages and disengages power
to the electric clutch.
The PTO light, in the Indicator Module, will be on when
the ignition key is in run or lights position and the power
take off (PTO) is engaged. When this light is on it is a
reminder the starter will not crank and to turn off the PTO
before getting off the tractor.
Engaging the Power Take Off (PTO)
1. Depress the brake pedal to stop the machine.
2. Pull the power take off (PTO) to on (Fig. 6).
2
3
4
1208
3. Run
4. Start