Flushing Solvent Disposal - New Holland T8010 Manual

Final System Oil Check
After the system has been drawn to a deep vacuum
and recharged,
1. Operate the A/C system for 15 minutes to
thoroughly circulate the PAG oil throughout the
system.
2. Install the gauge set and test the A/C system for
proper operation referring to the pressure/
temperature table on Page 33.
IMPORTANT: If oil level was measured and adjusted
properly according to the guidelines, Steps 3 and 4
are unnecessary.

Flushing Solvent Disposal

Never reuse contaminated flushing solvent.
Good stewardship of our natural resources is
everyone's business. New Holland flushing solvent is
a hazardous material. Never dispose of this solvent
by pouring it down the drain or treating it as water
soluble waste. Observe all local, state and federal
regulations when disposing the solvent.
In the United States, SAFETY-KLEEN will recycle
used flushing solvent. For more information on
SAFETY-KLEEN's recycling program, call 800-323-
5040.
Section 50 - Climate Control - Chapter 2
50-2-50
3. Recover refrigerant from the system. Use the
dipstick method to check the PAG oil level in the
compressor. If needed, adjust the oil level. See
Dipstick Method, page 80. For all Tractor
Models, the oil should cover five lines on the
dipstick.
4. Evacuate and recharge the system.