Transmission Controller Configuration And Calibration; When Calibration Is Required - New Holland T8010 Manual

TRANSMISSION CONTROLLER CONFIGURATION AND CALIBRATION

Important General Information
•
Before star ting the transmission calibration
pr oc e d ur e, c h e ck th e wi r i n g h a r n es s a n d
components for damage or loose connections.
R e p l a c e o r r e p a i r a n y d a m a g e d p a r t a s
necessary.
•
Before calibrating the transmission controller, be
sure the Standard Instrumentation (ICU) and
Armrest (ARM) controllers are calibrated.
•
Be sure that no persons are in front of or in back
of the tractor during calibration.
WARNING: Since the clutch calibration
process involves engaging transmission
clutches, this procedure should only be
p e r f o r m e d i n o p e n a r e a s , f r e e o f
!
obstructions. The tractor may experience a
small amount of movement during calibration
and the tractor operator should be ready to
stop the tractor at any time.
•
The transmission oil must be warmed to more
than 60°C (140°F).
•
The engine speed must be 1200 RPM or higher
during calibration.

When Calibration is Required

After s er vic e wor k has be en perfor med on a
transmission valve, master clutch, clutch pedal or the
transmission controller calibration is required.
C l u t c h c a l i b r a t i o n i s p e r fo r m e d t h r o u g h t h e
p r o g r a m m a b l e d i s p l ay o n t h e s t a n d a r d
instrumentation.
Section 55 - Electrical System, Controller - Chapter 6
M588
55-6-28
There are 6 main menu options in the transmission
configuration/calibration mode:
1. TRANS VIEW - This menu displays clutch
calibration values (milliamp and temperature).
System oil temperature, inching pedal calibration
values, software revision numbers, transmission
system pressure, and engine load in percent.
Normal tractor operation is allowed while this
menu is being displayed.
2. TRANS SETUP - This menu is used to enter the
clutch calibration and to set default gear values
for transmission controller.
3. TRANS ADJUST - This menu can only be
accessed when the Electronic Ser vice Tool
(EST) is in use on the tractor. Do Not Enter this
menu.
4. TRANS DIAG - This menu can only be accessed
when the Electronic Service Tool (EST) is in use
on the tractor. Do Not Enter this menu.
5. TRANS FSUS - This menu is used to setup for
suspended axle, view suspension menus,
calibrate, enter demo mode, or manual mode.
6. TRANS EXIT - This menu entry will exit the
calibration mode for the transmission system.
MD05F002