Accessing The Hvac Box - New Holland T8010 Manual

Hide thumbs Also See for T8010:

Table of Contents

NOTE: The following procedure applies to both the standard and Automatic Temperature Controlled (ATC)

Disconnect the harness to the right hand control

For tractors equipped with mechanical remote

hydraulic controls, the right hand control console

must be disconnected from the seat:

A. Loosen the 13 mm nut at the front of the right

hand side of the seat.

B. Remove the 18 mm bolt at the right hand rear

of the seat and remove the console. The

console can be rested on the rear shelf or slid

out the rear window and rested on the three-

point hitch for better access to the HVAC box.

Tilt the steering wheel to the full upright position.

Adjust seat to the full upright and back position.

Remove the floor mat wrap (1) which surround the

NOTE: If the return air filter covers are dislodged, be

sure to reinstall later.

Remove four bolts in the seat base corners.

Section 50 - Climate Control - Chapter 2

ACCESSING THE HVAC BOX

Table of Contents

T8020 T8030 T8040