Evaporator/Heater Assembly Installation - New Holland T8010 Manual

Hide thumbs Also See for T8010:

Table of Contents

Evaporator/Heater Assembly Installation

Lubricate new O-rings with clean mineral oil and

install new O-rings on the evaporator suction and

discharge lines.

Install the expansion valve. Tighten the fittings to a

torque of 18 to 25 lb ft (25 to 34 Nm). Use the two

wrench, two hand method when installing the

expansion valve to prevent damage to evaporator

Install the evaporator/heater assembly into the slide

mounting brackets of the HVAC box.

Install the sensor harness with grommet in slot in the

the evaporator. Reinstall the top gasket on the

NOTE: The gasket seals the top of the evaporator

and forces the air to move through the core rather

than around it. Replace the gasket if it is worn or

Section 50 - Climate Control - Chapter 2

Table of Contents

T8020 T8030 T8040