Blower Speed Driver (Atc Units Only) - New Holland T8010 Manual

Hide thumbs Also See for T8010:

Table of Contents

Blower Speed Driver (ATC Units Only)

To replace the blower speed driver in ATC systems,

with the keyswitch in the OFF position:

A. See ACCESSING THE HVAC BOX, page 90.

B. Remove the two screws securing the blower

speed driver assembly to the rear of the HVAC

C. Disconnect the six pin connector to the blower

speed driver.

D. Remove the four screws securing the driver to

the mounting plate.

E. Install a new blower speed driver with the

existing hardware. Install the 6-pin connector

on the driver, and secure the assembly to the

HVAC box rear with the two screws removed

earlier. Reinstall the seat.

Section 50 - Climate Control - Chapter 2

Table of Contents

T8020 T8030 T8040