Fault Code Inst 10034; Fault Code Inst 10035; Fault Code Inst 10036 - New Holland T8010 Manual

Controller Memory Error
Cause:
Controller memory error: loss of valid fuel table information.
Possible failure modes:
1. Updated software without loading new fuel table.
2. Memory defect or intermittent controller.
Solution:
Use the service tool fuel update screen to load a new fuel table into the instrumentation controller. Clear the fault
codes.
NOTE: Updating software to a later version requires loading a new fuel table.
Clear fault code. Shut down the tractor and restart. If the same fault appears again, make sure the controller has a
good connection (CN-2) to the battery and is properly grounded.
Clear the fault code. Shut down the tractor and restart. If problem persists, replace the controller.
NOTE: See schematic sections 24, 25 and 26 on the schematic poster.
Controller Memory Error - Loss Of Valid Radar Configration Information
Cause:
Controller memory error: loss of valid radar configuration information.
Possible failure modes:
1. Intermittent power supply or ground to controller.
2. Controller memory defect.
Solution:
Verify power and ground to the controller. Perform radar calibration per the operators manual.
1. Make sure the controller has a good connection (CN-2) to the battery and is properly grounded.
2. Perform the radar calibration for the instrumentation controller per the operators manual.
3. Clear the fault code. Turn the key switch OFF, then ON. If the same fault code appears again, replace the
instrumentation controller.
Controller Memory Error - Loss of Valid Timer Information
Cause:
Controller memory error: Loss of area, distance and timer information.
Possible failure mode:
1. Intermittent power supply or ground to controller.
2. Controller memory defect.
Solution:
Verify power and ground to the controller. Reset area, distance and timer values.
1. Make sure the controller has a good connection (CN-2) to the battery and is properly grounded.
2. Reset area, distance and timer values (see the operators manual instructions).
3. Clear the fault code. Turn the key switch OFF, then ON. If the same fault code appears again, replace the
instrumentation controller.
NOTE: See schematic sections 24 through 26 of the poster schematic.
Section 55 - Electrical System, Controller - Chapter 2

FAULT CODE INST 10034

FAULT CODE INST 10035

FAULT CODE INST 10036

55-2-10