Table of Contents
Advertisement
WARNING
ii
Maintenance, Safety, and Product Modification
• In order to protect the system controlled by the instrument, and the instrument itself,
and to ensure safe operation, observe the safety precautions described in this manual.
• If any protective or safety circuitry is required for the system used with this instru-
ment, or for the instrument itself, prepare and install it. Do not change the internal
parts or circuitry of the instrument in any way.
Disclaimers (Limitation of Liability)
Yokogawa grants no warranties other than the express warranty set forth under the
warranty provisions.
Yokogawa shall not be liable to you or any third party for any damage, including
consequential or incidental damages, arising out of or in connection with the use of this
equipment, defects beyond our knowledge, or any other contingency beyond our control.
High temperature, take care
When the sensor is powered on, the sensor tip gets very hot. Be careful not to touch it.
Power
Be sure to check the power supply voltage before turning on the power.
Grounding
Be sure to connect a Class D (100
minimize the possibility of shock.
Need for Grounding
Do not cut the internal or external protective ground wire, or remove the ground wire
from the terminal. This creates a shock hazard.
Do not Operate without Protective Grounding and Fuse
Do not operate the instrument without protective grounding and correct fuse.
Fuse
For safety, this product is fused internally. It is recommended that you ask the local
service representative to change the fuse; do not either change it yourself, or open the
case to check the fuse. Turn off the power switch and disconnect the instrument from
the power before changing the fuse. Do not use a fuse of different type or size, or short-
circuit the fuse holder.
ALM
FAIL
%
ppm
SET
AIR
1000ppm
4-20mA
MODE
ENT. .
F1.EPS
or less) ground before turning on the power, to
IM 1M11A01-03E
Advertisement
Table of Contents
