6.3 Configuring Data
Indication
IM 11M10A01-03E
(1) Configuring the sensor parameters
Upon replacing sensors, parameters must be configured following the chart below.
Parameters to be configured are specified in the Sensor Parameter Table (Figure 5.1)
attached on a new sensor.
Measured
%
Value
ppm
+ + ppm
%
FGIN
ppm
ENT
%
GIN.1
ppm
%
%
ppm
To be continued (to GIN.2)
Note) To check the sensor parameter, press [
on the display. Press [ENT] to confirm the parameter.
Figure 6.4 Flow Chart of Sensor Parameter Setting
Operational Flow Chart
(Note)
ppm + CAL
ppm + CAL
ENT
Gain 1 Value
%
ENT
Value
accepted
6. Operation
ppm+CAL
Changing
value
+ +
%]. [
] will appear
F6301E.EPS
6-5