Table of Contents
Advertisement
Operational Flow Chart
%
ppm
For readings in percentage,
the % lamp is ON and the
ppm lamp is OFF.
%
ppm
H.ALM
For the high alarm conditions,
the "H.ALM" lamp is ON and two
concentration unit lamps are OFF.
%
ppm
H.ALM
6-4
Measurement mode
Measured
Value
Press [ALM] for setting alarm setting
ALM
"HI.AL" is displayed to prompt setting entry
High Alarm
ALM
ENT
High Alarm Setting
ALM ENT
Press [ALM]
to skip reentry.
To low alarm alarm
setting entry
Figure 6.3 Operational Flow Chart
Press [ppm + CAL] to return to measurement mode
Press [ENT] to enter setting entry,
or press [ALM] to skip
ppm+CAL
Press [ppm + CAL] to return to measurement mode
Press [ENT] to enter setting entry. The setting displayed
will flash and "H.ALM" lamp turns on to prompt setting reentry.
Enter a new setting using [ ], [ ], [ppm], [%] keys
and press [ENT] to accept it.
ppm
Changing
value
High Alarm
No
> =
Low Alarm
Reset required if entered value is rejected.
Yes
Value
accepted
Return to measurement mode
Move to next setting mode
ppm+CAL
%
F6202E.EPS
IM 11M10A01-03E
Advertisement
Table of Contents
