Exit/Entry Zones In Area 1; Interior Zones In Area 1; Number Of Keypads In Area 1; Central Station Receiver 1 Tel. Number - NAPCO Gemini GEM-P1632 Programming Instructions Manual

WI897B 8/98
(Direct Entry)
for any additional zone(s). Press NEXT (
NOTE: Chime will automatically be programmed for all E/E zones. If you are programming a 2 Area system, enter the
total number of zones required for Areas 1 & 2. The Direct Address Program Mode can then be used to remove zone from
Area 1 and place them in Area 2. See Zone Options.
(Direct Entry)
additional zone(s). Press NEXT (
NOTE: All Interior zones will also be automatically programmed as "Exit/Entry Follower" zones. If you are programming a
2 Area system, enter the total number of zones required for Areas 1 & 2. The Direct Address Program Mode can then be
used to remove zones from Area 1 and place them in Area 2. See Zone Options.
(Direct Entry)
Programming. See Keypad Options.

(Direct Entry)
Pre-Dial Delay = "D"; Dial-Tone Detection = "E". Pressing the
save . Press NEXT (
NOTE: Central Station Receiver 2 and 3 Telephone Numbers can only be entered in Direct Address Programming. See
CS Receiver Options.
(Direct Entry)
NOTE: Central Station Receiver 2 and 3 Account Numbers can only be entered in Direct Address Programming. See CS
Reporting Options.
NAPCO Security Systems
Entry/Exit Zones in Area 1 (Appears for New Panel Only)
Directly enter the zone number of any zones which are to be used as

Entry/Exit zones. Valid entries are from 01 to 32. Directly enter each zone
number, including leading zeros. Use number buttons
NOTE: Press the
) button to proceed.
Interior Zones in Area 1 (Appears for New Panel Only)
Directly enter the zone number of any zones which are to be used as Interior

Zones. Valid entries are from 01 to 32. Directly enter each zone number,
including leading zeros. Use number buttons
Press the
) button to proceed.

Number of Keypads in Area 1


Directly enter the total number of Keypads to be installed in Area 1. Valid
entries are from 01 to 07. Directly enter the number of keypads, including
leading zeros. Use number buttons
button for a zero. Press
proceed. NOTE: Area 2 keypads can only be assigned in Direct Address
Central Station Receiver 1 Telephone Number
Using number buttons, enter telephone number of up to 16 digits including-
prefix letters, if necessary, for receiver 1. Use number buttons
through
) button to proceed.


Central Station Receiver 1 Account Number

Enter an account number of up to four digits. Use number buttons

through
press
NEXT (

button for a zero. Press

button for a zero. Press
to save . Press NEXT (


for digits 1–9; press the
through
button will produce a blank space (•). Press
for digits 1–9. NOTE: Press the
button for a blank space (•). Press
) button to proceed.
GEM-P1632 Programming Instructions
through
to save and then repeat
through
to save and then repeat for any

through . NOTE: Press the

button for a zero and
for letters B–F, respectively. NOTE:

button for a zero and
to save . Press
Page 7
.
. NOTE:
) button to
to