WI897B 8/98
(Direct Entry)
(Direct Entry)
Central Station Receiver 1 Account Number
(Direct Entry)
Central Station Receiver 1 Format
(Direct Entry)
DATA
CS RECEIVER 1 FORMAT
ENTRY
•(blank)
Ademco Slow, Silent Knight Slow
2
Radionics Fast
3
Silent Knight Fast
4
Radionics, DCI, Franklin Slow
NAPCO Security Systems
Number of Keypads in Area 1
Directly enter the total number of Keypads to be installed in Area 1. Valid
entries are from 01 to 07. Directly enter the number of keypads, including
leading zeros. Use number buttons
button for a zero. Press
proceed. NOTE: Area 2 keypads can only be assigned in Direct Address
Programming. See Keypad Options.
Central Station Receiver 1 Telephone Number
Using number buttons, enter telephone number of up to 16 digits including-
prefix letters, if necessary, for receiver 1. Use number buttons
through
for digits 1–9; press the
through
Pre-Dial Delay = "D"; Dial-Tone Detection = "E". Pressing the
will produce a blank space (•). Press
to proceed.
NOTE: Central Station Receiver 2 and 3 Telephone Numbers can only be
entered in Direct Address Programming. See CS Receiver Options.
Enter an account number of up to four digits. Use number buttons
through
for digits 1–9. NOTE: Press the
press
NEXT (
) button to proceed.
NOTE: Central Station Receiver 2 and 3 Account Numbers can only be
entered in Direct Address Programming. See CS Reporting Options.
From the table below, enter the central station's receiver format. Use number
buttons
through
and press
for letters B–E, respectively. Press
(
) button to proceed.
NOTE: Central Station Receiver 2 and 3 Formats can only be entered in
Direct Address Programming. See CS Receiver Options.
DATA
CS RECEIVER 1 FORMAT
ENTRY
5
Universal High Speed
B
SIA
C
Ademco Point ID
E
Pager
through
to save. Press NEXT (
for letters B–F, respectively. NOTE:
to save . Press NEXT (
button for a blank space (•). Press
. NOTE: Press the
for a blank space (•). Press
GEM-P1632 Programming Instructions
Page 13
. NOTE: Press the
) button to
button for a zero and
button
) button
button for a zero and
to save . Press
button for a zero.
through
to save. Press NEXT