Gem-Rp2Ase2 Keypad; Number Of Zones In Area 1; Panel Zone Doubling; Fire Zones In Area 1 - NAPCO Gemini GEM-P1632 Programming Instructions Manual

WI897B 8/98
A. GEM-RP2ASe2 Keypad
Enter the Dealer Security Code (default = 456789) for a new panel or enter your custom Dealer Program




 

 

Code if programmed. Press NO (

 
 
  
  



  
NEXT/YES
    "


P R I O R / N O
  
AREA

  
    Dealer Program Mode. In each of the following steps, press the
R
( ) button to go forwards, the PRIOR (
button twice to exit at any time.
(Direct Entry)
Areas 1 & 2. The Direct Address Program Mode can then be used to remove zones from Area 1 and place them in Area
2. See Zone Options. If Programming a Wireless Only system, or using wireless only on Zones 9-32, enter the total
number of zones in system. Enter the transmitter points in the RF Transmitter section of the Easy Menu Driven
Programming Mode.
(Press YES or NO)
Fire Zones in Area 1 (Appears for New Panel Only)
(Direct Entry)
zones required for Areas 1 & 2. The Direct Address Program Mode can then be used to remove zones from Area 1 and
place them in Area 2. See Zone Options.
NAPCO Security Systems
) repeatedly until "
", you can scroll back by pressing the
Total Number of Zones in Area 1 (Appears for New Panel Only)

Directly enter the total number of zones to be programmed for Area 1. Valid
entries are from 01 to 32. Directly enter the total number of zones, including
leading zeros. Use number buttons
button for a zero. The system is based on groups of 4 zones each
(after the first 8 zones), and will automatically round up to the next group of
4. For example, if you enter 18, it will automatically convert this to 20 zones.
Press to save. Press NEXT (
programming a 2 Area system, enter the total number of zones required for

Panel Zone Doubling (Appears for New Panel Only)
If the total number of zones in Area 1 entered was 16 or greater, press YES
( ) to effectively double the capacity of the control panel's hard wired
zones from 8 to 16. The 16 zones will no longer be EOL zones, but will be

designated for Normally Closed devices only. The terminal for Zone 1 will
now support Zones 1 and 9 with the use of the supplied EZ Zone
TM
Doubling
Installation Instructions). If Panel Zone doubling is not desired, press NO
).
(
Enter the number of any zones which are to be used as Fire Zones (both
2-wire, 4-wire or wireless). Valid entries are from 01 to 32. Directly enter
each zone number, including leading zeros, and press
repeat for any additional zone(s). Press NEXT (
NOTE: If you are programming a 2 Area system, enter the total number of

button. Press YES (
) button to go backwards, the

) button to proceed. NOTE: If you are
resistors, E & Z supplied. (Refer to Wiring Diagram and
GEM-P1632 Programming Instructions
Page 11

" is displayed. NOTE: If you pass
) to enter the
button to set cursor, the NEXT
button to save and the
through . NOTE: Press the

to save, and then
) button to proceed.