2-Wire Fire Zones In Area; Local Or Central Station Reporting System; Exit/Entry Zones In Area 1; Interior Zones In Area 1 - NAPCO Gemini GEM-P1632 Programming Instructions Manual

Page 12
(Direct Entry)
(Press YES or NO)
Entry/Exit Zones in Area 1 (Appears for New Panel Only)
(Direct Entry)
Interior Follower Zones in Area 1 (Appears for New Panel Only)
(Direct Entry)
GEM-P1632 Programming Instructions
2-Wire Fire Zones in Area 1 (Appears for New Panel Only)
Enter the number of any Fire Zones (from previous question) which are to be
used with 2-wire smoke detectors. The only valid entries are 07 and 08.
Directly enter each zone number, including leading zeros. Press
and then repeat for any additional zone(s). NOTE: Only zones which have
been designated as Fire Zones in the prior question may be programmed as
2 Wire Fire zones. Press NEXT (
be set to "2-WF" position for 2-wire fire zones (refer to Installation Instruc-

tions).
Local or Central Station Reporting System (Appears for New Panel Only)
Press YES ( ) button for all zones to report; press NO (
for no zones to report (LOCAL SYSTEM).

Directly enter the zone number of any zones which are to be used as Entry/
Exit zones. Valid entries are from 01 to 32. Directly enter each zone number,
including leading zeros. Use number buttons
Press the button for a zero. Press
additional zone(s). Press NEXT (
NOTE: Chime will automatically be programmed for all E/E zones. If you are
programming a 2 Area system, enter the total number of zones required for
Areas 1 & 2. The Direct Address Program Mode can then be used to re-
move zone from Area 1 and place them in Area 2. See Zone Options.

Directly enter the zone number of any zones which are to be used as Interior
Follower Zones. Valid entries are from 01 to 32. Directly enter each zone
number, including leading zeros. Use number buttons
. NOTE: Press the
repeat for any additional zone(s). Press NEXT (
NOTE: All Interior Follower zones will also be automatically programmed as
"Exit/Entry Follower" zones. If you are programming a 2 Area system, enter
the total number of zones required for Areas 1 & 2. The Direct Address
Program Mode can then be used to remove zones from Area 1 and place
them in Area 2. See Zone Options.

) button to proceed. NOTE: JP3 must

through
to save and then repeat for any
) button to proceed.

button for a zero. Press
) button to proceed.
NAPCO Security Systems
WI897B 8/98
to save,
) button
. NOTE:
through
to save and then