Zone Descriptions - NAPCO Gemini GEM-P1632 Programming Instructions Manual


WI897B 8/98
Enter the new User Code using the number buttons (0-9). If an old code is displayed, program over it. To erase the digit at the
cursor, press

Press the button to save the code in memory.
Repeat this procedure for each user. To proceed to Zone-Description programming, press the NEXT (
PRIOR ( ) button.
GEM-RP2ASe2 Keypad
(Direct Entry)

Enter an identifying description for each
zone. Buttons and
cursor position; buttons

scroll numbers, letters, punctuation marks,
etc.
Position the cursor over the displayed
Zone Number (i.e., "01") using buttons
and .
Change the Zone Number using buttons
and .
Position the cursor over the first
character of the description field.
Advancing the cursor between
characters, program a description of up
to two lines for the new zone using
buttons and
Press the button to save. Advance to the next zone as in Steps 1 and 2 above and repeat this procedure until all zones have
been programmed.
NAPCO Security Systems
button.
To Program User Codes
1. Enter 2-digit User Number
(01-32) directly using
number buttons (0-9).
2. Press the
3. Enter Code (1-6 digits)
directly using number
buttons (0-9).
4. Press the
each code.
NOTE: Press
To continue press


To Program Zone Descriptions
1. Set the Cursor Position using

buttons
2. Select characters for zone
set the
description using buttons


and
and
4. Press the
each descriptor.
NOTE: Press
To continue press
.


button.


button to save

 
button to clear character at cursor.
or
Programming User Codes


and .
.
button to save

 
button to clear character at cursor.
or
Programming Zone Descriptions
GEM-P1632 Programming Instructions
Page 39

) button or the
button.
button.