Easy Menu Driven Program Mode; Dealer Program - Preliminary Information; Accessing Dealer Program Mode; Customizing A Default Program - NAPCO Gemini GEM-P1632 Programming Instructions Manual

WI897B 8/98
Only Keypad #1 may be used for both dealer and user programming, however this keypad may be located in any area.
The Default Dealer Code is
to program a custom Dealer Code, which replaces the Default Dealer Code. If you clear your Dealer Code, use the Default Dealer
Code once again to enter programming.
After entering codes or data, press the save
If the keypad is in the Program Mode and no activity is detected for longer than 4 minutes, a steady tone will sound. Silence the
sounder by the button to continue, or by pressing the
A panel that has been SYSTEM RESET performs identically to a new panel.
When programming a Multiple Area System, Direct Address Programming Mode must be used to complete the program.
KEYPAD #1: For ease of programming, it is recommended that a GEM-RP1CAe2 be used as Keypad #1. (Regardless of
which keypad is selected, all new keypads are configured as Keypad #1 out of the box.)
If a GEM-RP2ASe2 is used, configure address jumpers as Keypad #1 (see Configuring the GEM-RP2ASe2 Keypad.).
Use the button to manually scroll through each selected option and at the end of each programming line.
1. Press
2. Press
3. Press
4. Press
Number of Zones in Area 1
Panel Zone Doubling
Fire Zones in Area 1
2-Wire Fire Zones in Area 1
Local or Central station Reporting
Exit/Entry Zones in Area 1
For any new panel, you can design a default program that will best suit your application. Using this procedure, you will
configure the panel for:
NEW PANELS: The custom default program may be created for new panels only. Once the panel has been programmed
by any means, the number of areas, zones and keypads will be suppressed and cannot be changed. Should it be
necessary to create a new custom default program, (a) from the Dealer Program Mode, press the
the Direct Address Program Mode; (b) access Location 1197 (Clear Program); (c) press the
NAPCO Security Systems

button. Data will not be stored into memory unless it is pressed.



Dealer Code (Default = 456789)
Until "

 
  " (GEM-RP1CAe2) or
"     " (GEM-RP2ASe2)
appears on LCD screen.
To Enter Dealer Program Mode
To Exit Dealer Program Mode when finished
Interior Zones in Area 1
Number of Keypads in Area 1
CS Receiver 1 Telephone Number
CS Receiver 1 Account Number
CS Receiver 1 Format
User Codes
. Use this code to enter the Dealer Program Mode


button to exit.
RF Transmitter Points
Key Fob Transmitters
Zone Descriptions (GEM-RP1CAe2 Keypad
Only)
Dealer Code
GEM-P1632 Programming Instructions
Page 5



   


 

         
 
  
 
       



  
NEXT/YES
   
PRIOR/NO
  
AREA

  
   
R


button to enter
button and start over.