User Program Mode; Preliminary Information; Accessing User Program Mode; User Codes - NAPCO Gemini GEM-P1632 Programming Instructions Manual

Page 38
The User Program Mode is covered in detail in the operating instructions for the keypad in use.
Only Keypad #1 may be used for programming, however this keypad may be located in any area.
The Program Mode cannot be accessed while the communicator is transmitting except during the first three minutes after
power-up.


After entering codes or data, press the save
If the keypad is in the Program Mode and no activity is detected for longer than 4 minutes, a steady tone will sound. Press the
button to silence the sounder and exit the User Program Mode.

NOTE: For ease of programming, it is recommended that a GEM-RP1CAe2 be used as Keypad #1. (A new GEM-RP1CAe2 is auto-
matically configured as Keypad #1.)
If a GEM-RP2ASe2 is used, configure address jumpers as Keypad #1 (see the section of this manual Configuring the GEM-RP2ASe2
Keypad). Use the button to manually scroll the display at the end of each programming line.
1. Press
2. Press
3. Press
4. Press
GEM-RP1CAe2 Keypad (Direct Entry)
Up to 32 User Codes may be programmed.
NOTE: In this mode, only the code is pro-

grammable; the accompanying Area Options
must be programmed in the Dealer Program
Mode (see page 8).
Use the button to place the cursor
over the User Number.
Enter a User Number (01–32) using the
number buttons. The cursor will then
advance to the User Code and read the
existing code, if any.
GEM-P1632 Programming Instructions
button. Data will not be stored into memory unless this button is pressed.








New Panel (Default User Code = 123)
Existing Panel (Any Code with User Program Option Enabled)

Until "

 
 " (GEM-RP1CAe2) or
"      " (GEM-RP2ASe2)

appears on LCD screen.
To Enter User Program Mode
To Exit User Program Mode when finished


To Program User Codes
1. Set Cursor Position using
the
2. Enter 2-digit User Number
(01-32) directly using
number buttons (0-9).
3. Enter Code (1-6 digits)
directly using number
buttons (0-9).
4. Press the
each code.
NOTE: Press
To continue press
button.



 
button to save
button to clear character at cursor.
or
Programming User Codes
WI897B 8/98





 

  
   
User Code NOT USED
button.
NAPCO Security Systems


 

        
 
    
 


 
NEXT/YES
  
PRIO R/NO

ARE A
R