WI1148B 10/06
EASY MENU DRIVEN PROGRAM MODE
DEALER PROGRAM - PRELIMINARY INFORMATION
The Default Dealer Code is
to program a custom Dealer Code, which replaces the Default Dealer Code. If you clear your Dealer Code, use the Default
Dealer Code once again to enter programming.
After entering codes or data, press the save
If the keypad is in the Program Mode and no activity is detected for longer than 4 minutes, a steady tone will sound.
Silence the sounder by the
When programming a Multiple Area System, Direct Address Programming Mode must be used to complete the program.
ACCESSING DEALER PROGRAM MODE
1. Press 456789 R
2. Press "PRIOR/NO" button until "TURNON PROG Y/N" (GEM-RP2ASe2/
3. Press "NEXT/YES" button to Enter Dealer Program Mode.
4. Press
CUSTOMIZING A DEFAULT PROGRAM
For new panels, you can design a default program that will best suit your application. Using this procedure, you will configure the panel for:
•
Number of Zones in Area 1
•
•
•
2-Wire Fire Zones in Area 1
•
•
•
Interior Zones in Area 1
•
•
•
•
This procedure will automatically set up system keypads, EZMs, wireless transmitters, etc. After your basic default program has
been loaded, you may alter it as necessary in the Direct Address Program Mode.
NEW PANELS: The custom default program may be created for new panels only. Once the panel has been programmed by any
means, the number zones will be suppressed and cannot be changed. Should it be necessary to create a new custom default
program, (a) from the Dealer Program Mode, press the
2285 (Clear Program); (c) press the
L
NAPCO Security Systems
4 5 6 7 8 9
U
button. Data will not be stored into memory unless
G
button to continue, or by pressing the
Dealer Code (Default = 456789)
GEM-K2AS) or "17" (GEM-RP3DGTL/GEM-K3DGTL or
GEM-RP4RFC/GEM-K4RF) appears on the LCD screen.
to exit Dealer Program Mode when finished.
CC
•
50mS Loop Response Zones
required for Loop Response time in UL installations)
•
Aux Output Activated on Alarm Zones
•
•
Keypad Sounder on Alarm Zones
•
Auto Bypass re-entry Zones
•
Enable no EOLR Zones
•
•
•
•
C
U
button and start over.
. Use this code to enter the Dealer Program Mode
C
button to exit.
(Note: 750mS is
button to enter the Direct Address Program Mode; (b) access Location
X
GEM-P1632 Programming Instructions
U
is pressed.
•
Central Station Receiver 1 Tel. Number
•
Central Station Receiver 1 Account Number
•
Central Station Receiver 1 Format
•
•
•
•
Keyfob Transmitters
•
•
•
Test Timer
Page 5