Clear Program Options; User Program Mode; Preliminary Information; Accessing User Program Mode - NAPCO GEMINI GEM-P1632 Programming Instructions Manual

WI1148B 10/06
CLEAR PR OGRA M O PTI ONS (AD DRESS 228 5 & 2 2 86 )
2285 XX
GEM-RP1CAe2 Keypad
2285 XX
GEM-RP2ASe2 Keypad
2286 XX
GEM-RP1CAe2 Keypad
2286 XX
GEM-RP2ASe2 Keypad

USER PROGRAM MODE

PRELIMINARY INFORMATION

The User Program Mode is covered in detail in the operating instructions for the keypad in use.
The Program Mode cannot be accessed while the communicator is transmitting except during the first three minutes after power-
up.
After entering codes or data, press the save
If the keypad is in the Program Mode and no activity is detected for longer than 4 minutes, a steady tone will sound.
Press the C button to silence the sounder and exit the User Program Mode.
Use the R button to manually scroll the display at the end of each programming line.

ACCESSING USER PROGRAM MODE

1. Press EEEEEE
Existing Panel (Any Code with User Program Option Enabled)
2. Press Q
Until "TURNON PROG Y/N" (GEM-RP2ASe2/GEM-K2AS) or "17" (GEM-RP3DGTL/GEM-K3DGTL
or GEM-RP4RFC/GEM-K4RF) appears on the LCD screen.
3. Press P
To Enter User Program Mode.
4. Press C
To Exit User Program Mode when finished.
L
NAPCO Security Systems
Clear Dealer Program (Erases Dealer Program)
Access address 2285, then press the
allowed.
NOTE:
again.
Cold Start (Erases Entire Program)
Access address 2286, then press the
allowed.
NOTE: Some features (schedules) can only be programmed again with
the Downloading Software. NOTE: Some features (schedules) can only
be programmed again with the Downloading Software. If power fails, time
and date restarts at 00:00:00 and a date of 01-01-04 (January 1, 2004).
U
button. Data will not be stored into memory unless this button is pressed.
New Panel (Default User Code = 123)
This erases the dealer program. Use this feature to start
a customized default program.
System Status Memory is erased where Scheduled Data
and Zone Descriptions are maintained.
Enter Easy Menu Driven Program Mode to program system
This erases the entire program including Dealer Program
by erasing Program Data, Zone Description Data and
System Status Data (similar to a new panel).
R
X
GEM-P1632 Programming Instructions
Page 51
Program Data and
U
button. Data entry is not
U
button. Data entry is not