Basic Device Setup - Emerson Rosemount 3051CF Series Reference Manual

Reference Manual
00809-0100-4774
condition exists. Check the device to determine the type of abnormal condition and
recommended actions to resolve it.
Plantweb alert priorities
Configure Plantweb
different condition prioritiesl, ranging from the lowest priority of 0 to the highest priority
of 15. This is done using the following parameters.
1. FAILED_PRI to specify the priority of FAILED_ALM
2. MAINT_PRI to specify the priority of MAINT_ALM
3. ADVISE_PRI to specify the priority of ADVISE_ALM
Plantweb alert priority is configured using DeltaV and is not part of the DD functionality.
2.7

Basic device setup

CAUTION
Set all transmitter hardware adjustments during commissioning to avoid exposing the
transmitter electronics to the plant environment after installation.
Note
The information contained within
Guide. Reference
more detailed configuration information.
2.7.1 Configure
Each F
performing configurations. Some use DD methods for configuration and to display data
consistently across platforms. There is no requirement that a host or configuration tool
support these features. Use the following block examples to do basic configuration to the
transmitter. For more advanced configurations, reference
through
Note
DeltaV
control studio for the Function Blocks.
Configure the AI block
The screens used for each step are shown in
instructions for each step of AI block configuration are provided in
Reference Manual
™
alert priorities in DeltaV
Analog input (AI) function block
Fieldbus host or configuration tool has a different way of displaying and
OUNDATION
Advanced device setup
™
users should use DeltaV Explorer for the Resource and Transducer blocks and
™
. Plantweb alerts can have any of 16
Basic device setup is the same as in the Quick Start
through
in this manual.
Figure 2-13. In addition, step-by-step
Configuration
July 2020
Advanced device setup for
Analog input (AI) function block
Figure 2-13.
33