Emerson Rosemount 3051CF Series Reference Manual page 36

Configuration
July 2020
2. Select the Signal Conditioning L_TYPE from the dropdown menu:
3. Set XD_SCALE to the 0% and 100% scale points (the transmitter range):
36
• To use guided setup:
a. Navigate to Configure > Guided Setup.
b. Select AI Block Unit Setup.
Note
Guided setup will automatically go through each step in the proper order.
• To use manual setup:
a. Navigate to Configure > Manual Setup > Process Variable.
b. Select AI Block Unit Setup.
c. Place the AI block in Out of Service mode.
Note
When using manual setup, perform the steps in the order described in
the AI block.
Note
For convenience, AI Block 1 is pre-linked to the transmitter primary variable and
should be used for this purpose. AI Block 2 is pre-linked to the transmitter sensor
temperature. You must select the the channel for AI Blocks 3 and 4. The control
host and some asset management hosts can deconfigure the factory assigned links
and assign the primary variable and sensor temperature to other AI blocks.
• Channel 1 is the primary variable.
• Channel 2 is the sensor temperature.
If the F Fieldbus Diagnostics Option Code D01 is enabled, these
OUNDATION
additional channels are available.
• Channel 12 is the SPM mean.
• Channel 13 is the SPM standard deviation.
To configure SPM, refer to
Note
Step 3 through Step 6 are all performed in a single step by step method under
guided setup.
Note
If the L_TYPE selected in
If the L_TYPE selected is Indirect,
skips any unneeded steps.
a) Select L_TYPE: Direct for pressure measurements using the device default
units.
b) Select L_TYPE: Indirect for other pressure or level units.
c) Select L_TYPE: Indirect Square Root for flow units.
Advanced pressure diagnostics.
Step 2 is Direct, Step 3, Step 4
Step 5 is not needed. Guided setup automatically
Reference Manual
00809-0100-4774
Configure
and Step 5 are not needed.
Rosemount 3051