Emerson Rosemount 3051CF Series Reference Manual page 38

Configuration
July 2020
8. Review transmitter configuration and place in service.
9. Set switches and software write lock.
Enable software write lock
Procedure
1. Navigate from the Overview screen.
2. Perform Write Lock Setup to enable software write lock.
38
• To use guided setup:
— Navigate to Configure > Guided Setup, and select Local Display Setup.
Note
Guided setup will automatically go through each step in the proper order.
— Check the box next to each parameter to be displayed to a maximum of four
parameters. The LCD display will continuously scroll through the selected
parameters.
• To use manual setup:
— Navigate to Configure > Manual Setup, and select Local Display Setup.
— Check each parameter to be displayed. The LCD display will continuously
scroll through the selected parameters.
a) To review the transmitter configuration, navigate using the guided setup
navigation sequences for AI Block Unit Setup, Change Damping, and Set up LCD
Display.
b) Change any values as necessary.
c) Return to the Overview screen.
d) If mode is Not in Service, click the Change button, and then click Return All
to Service.
Note
If hardware or software write protection is not needed, you can skip
a) Check switches (see
Note
You can leave the Write Lock switch in the locked or unlocked position. The
Simulate Enable/Disable switch may be in either position for normal device
operation.
a) Select Device Information.
b) Select the Security and Simulation tab.
Figure 1).
Reference Manual
00809-0100-4774
Step 9.
Rosemount 3051