Emerson Rosemount 3051CF Series Reference Manual page 37

Reference Manual
00809-0100-4774
4. If L_TYPE is Indirect or Indirect Square Root, set OUT_SCALE to change
5. If L_TYPE is Indirect Square Root, a LOW FLOW CUTOFF function is available.
6. Change damping.
7. Configure optional LCD display (if installed).
Reference Manual
a) Select the XD_SCALE_UNITS from the dropdown menu.
b) Enter the XD_SCALE 0% point.
This may be elevated or suppressed for level applications.
c) Enter the XD_SCALE 100% point.
This may be elevated or suppressed for level applications.
d) If L_TYPE is Direct, you may place the AI block in AUTO mode to return the
device to service.
Guided setup does this automatically.
engineering units.
a) Select the OUT_SCALE UNITS from the dropdown menu.
b) Set the OUT_SCALE low value.
This may be elevated or suppressed for level applications.
c) Set the OUT_SCALE high value.
This may be elevated or suppressed for level applications.
d) If L_TYPE is Indirect, you may place the AI Block in AUTO mode to return the
device to service.
Guided Setup does this automatically.
a) Enable LOW FLOW CUTOFF.
b) Set the LOW_CUT VALUE in XD_SCALE UNITS.
c) You may place the AI Block in AUTO mode to return the device to service.
Guided Setup does this automatically.
• To use guided setup:
— Navigate to Configure > Guided Setup, and select Change Damping.
Note
Guided setup automatically goes through each step in the proper order.
— Enter the desired damping value in seconds. The permitted range of values is
0.4 to 60 seconds.
• To use manual setup:
— Navigate to Configure > Manual Setup > Process Variable, and select
Change Damping.
— Enter the desired damping value in seconds. The permitted range of values is
0.4 to 60 seconds.
Configuration
July 2020
37